Overview of guitar and work
ll  Page 1  ll  Page 2  ll  Page 3  ll  Page 4  ll  Page 5  ll  Page 6  ll  Page 7 ll  Page 8  ll
Overview of guitar and work
ll  Page 1  ll  Page 2  ll  Page 3  ll  Page 4  ll  Page 5  ll  Page 6  ll  Page 7 ll  Page 8  ll
Overview of guitar and work
ll  Page 1  ll  Page 2  ll  Page 3  ll  Page 4  ll  Page 5  ll  Page 6  ll  Page 7 ll  Page 8  ll
Empty micro neck tilt screw sleeve hole.
Someone installed a bolts plate some time in the past;  But original paint in counter-sunk screw holes indicates the original configuration was without a plate.  If a plate is desired, I reccommend stailess steel.  Plates are quite easy to make once the desired material is acquired.
The chip reported by previous owner's desctription posted on my description page.
Some of the buffing surface scratches reflecting shop light.
Some of the buffing surface scratches shown along this rear edge of body.
>
<